How long will my vent filter/desiccant cartridges last?

What is the function of the blue wire from the submersible cable?

What are the most common reasons customers keep buying your products?

How do I know whether I need a stainless steel or Titanium transducer/transmitter and polyurethane or Tefzel jacketed cable?

I want to use a KPSI Industrial Pressure Transducer (Series 27, 28, or 30) on the standpipe of my elevated water tank but it will be located in a vault that may flood. What can I do?

Can I have my KPSI transducer/transmitter recalibrated?

I have lost the calibration sheet for my transducer/transmitter. Can I get a replacement copy?

How far off of the bottom of the well should I set my level transmitter/transducer?

What is the turnaround time on repairs?

What is the mean time between failure for your submersible pressure transducer?

How many pressure measurements can you make before the diaphragm on the pressure sensor fails?

What happens when you freeze your transducer in a column of water?

What is the longest length of time one of your products has run continuously?

Does it make any difference if I mount the transducer in a vertical or horizontal position?

What wire gauge should I limit myself to when connecting to your 22 AWG wire?

Why do you use 316 SS housings and sensors for your standard transducers?

What is the longest length of cable you have attached to a submersible transducer?

My cable on the submersible always seems to get cut and damaged. What am I doing wrong?

What installation ideas do you have to help me get rid of electrical noise interfering with the signal?

I need proof pressure much greater than 1.5 X. How can you help me?

What is the response time of your transducer?

How much shock can your submersible transducers withstand?

I have an application where the transducer is frequently damaged by voltage spikes. What can be done to prevent this?

What is the best way to mark my cable?

How do I attach your vent filter or aneroid bellows to my cable vent tube?

Any ideas for preventing marine growth on your submersible transducers?