Page 1-6
Section 1.3.2 Manifolds and Pressure Connections
Add the following NOTE to the paragraph:
"9816 scanners with front-mount quick disconnect (QDC) panels have all necessary input fittings on the panel. Therefore, the run reference (RUNREF) input ports on the rear of the 98RK are not utilized. Previously, compression fittings were installed in these rear ports. The input ports now have plugs, rather than fittings, installed.
"Page 5-1 Figure 5.1 (Exploded View of 9816 Calibration Manifold)
Replace the drawing on Page 5-1 (Figure 5.1) with the
following:
Figure 5.1
Exploded View of 9816 Calibration Manifold
Page 5.10
Paragraph (4) should read;
Slide the front panel forward as far as it will go (approximately d").
Page 5-16Section 5.1.6.2 Tubing Plate O-Ring ReplacementAdd a new paragraph (5) to read as follows:
"Inspect for the presence of optional shim washers around each of the
six (6) screws. If washers are present, retain for use in reassembly."
Renumber remaining paragraphs accordingly.Change paragraph (7) to read: (additions are in italics)
Examine the tubing plate and calibration manifold to verify that no
contaminants are on either surface. This generally requires microscopic
examination. Replace the tubing plate by slowly placing the plate on the
calibration manifold housing. Make sure the O-ring/cup seal side is down
toward the pneumatic sliding manifold and the guiding pin on the calibration manifold housing fits into the mating hole of the tubing plate. Also, ensure that shim
washers, if used, are reinstalled between the tubing plate and the calibration
manifold assembly.
Page 5-20
Section 5.1.6.6 Module Rear Manifold O-Ring Replacement
Paragraph (4a) to read as follows:For glued O-ring replacement (O-rings will be black)
(4a) There are only two O-rings on this panel that are glued; the larger
black ones. One is for the purge port and the other surrounds a
blanking pin. Using a glue syringe, line the O-ring cup(s) with appropriate
glue, such as 3M Scotch Grip 1357. Insert a new O-ring (PSI part number
61-03-50120) and press it into the cup with your hand. Allow the glue to dry for
approximately 10-15 minutes. Clean any excess glue with appropriate cleaning
solvent, and dry. Be extremely careful not to allow any excess glue to
cover the tubing ports.
Pages 5-21 and 5-22
Section 5.1.6.7 Rear Panel Quick Disconnect (QDC) O-Ring Replacement
NONE of the O-rings on this panel are glued. All are pressed into place
over a flared center tube.
PSI part number for these O-rings is 61-03-4762. All
O-rings are black.
Delete paragraph (6) and renumber the remaining paragraphs (6) through (10).
Pages 5-22 and 5-23
Section 5.1.6.8 Front Panel Tubing Plate Quick Disconnect (QDC) O-Ring
Replacement
NOTE: NONE of the O-rings on this plate are glued. All O-rings
are pressed into place over a flared
center tube. PSI part number for these
O-rings is 61-03-4762. All O-rings are black. |
Delete paragraph (4a)"For glued O-ring replacement..."
Renumber paragraph (4b) to (4a), and delete the words "For all"
following the new paragraph (4a).
|
